Bosch TS1002 Table Saw, outfeed support
| Overall Rating |   |
 |
outfeed support
The outfeed support is a handy thing to have on a table saw. The only problem that I have encountered in useing it is that flexible materials like thin plywood tend to flex between the saw and the outfeed support and hit the support instead of going on top of it. This problem can be fixed by using a peice of scrap as a ‘brige’ to help the material make it onto the suport.
Update (2/5/2012): This item is currently on sale here for the lowest price I’ve seen.
The featured review for this product, Bosch TS1002 Table Saw Rear Outfeed Support Extension Tools & Hardware, was written by .
The average rating for this item is out of 5 stars, according to 3 reviews.
- Related posts on bosch
- A close look at Bosch Microwaves | Ge Appliance
Related posts:
- Bosch TS1007 Dado Insert, Info on how to use dado..
- Bosch 1587AVSK 5 Amp, THE BEST. PERIOD.
- Bosch PR010 Round, Get a centering cone.
- Bosch PS10-2A 12-Volt, Bosch PS10-2A Impact Driver..
- Bosch 1617EVSPK 12 Amp, Beware - high tolerance..
Tags: bosch, bosch productstable sawsbosch tools, bosch table saw, bot, extensions, large power tool, outfeed extension, portable, portable saws, portable table saw, saw, stops, table saw, woodworking
Posted on: April 1, 2010
Filed under: Reviews
Reviews (3)
Anonymous
March 1st, 2010 at 2:25 pm
outfeed support
Rated 4 stars.
Michael R. Golden
March 4th, 2010 at 4:19 am
mike in maine
After reading some of the poor reviews for this product I had some reservations.When I unpacked and assembled the extention I soon discovered the problems others had described.1st the miter guide slots don’t align with the notches in the extention.2nd the sliding rails are too far apart, one owner had elongated the mounting holes to address this.The actual problem is in the illustrations in the instructions! The pictures of the model 4000 saw and the 4001 saw are reversed.Simply mount one bracket facing outward[the one with the lock knob]and the other facing inward,as pictured for the model 4001,and the extention fits and operates smoothly! Perhaps BOSCH should correct the instructions instead of agreeing they had made a manufacturing error to appease a dissatisfied customer. I hope this helps others who encounter this problem.
D. Ward
March 25th, 2010 at 11:34 am
Must have for large pieces
Bolts on easily. Supports well after the cross bar is redrilled to align the support with the table. It is 1/2″ low to the table when at full extension. Only one thumbscrew included for locking position but both brackets are drilled and tapped for it.
Must be careful when cutting 4×8 sheets as the saw can tip with this support at full extension and the board hanging off it.
Leave a reply